The primary physical characteristics of lubricants that are affected by temperature include viscosity, viscosity index, pour point and the base oil. Let's deal with these individually.

Viscosity

The viscosity of an oil has been said to be the most important consideration when selecting a lubricant. The viscosity of an oil is its ability to flow or its internal resistance to flow.

For example, when an oil film forms between a bearing and a shaft, some of the oil's molecules are attracted to the surface of the shaft, while other oil molecules are attracted to the bearing surface. This is called the shear rate and is directly affected by the oil's viscosity and operating temperatures. A multi-grade oil with a lower (thinner) viscosity will generally have a higher potential shear rate, while a single viscosity oil will generally have a lower potential shear rate.

Since oil with a lower viscosity and high potential shear rate must still maintain a sufficient oil film, it is quite apparent that as temperatures rise, the oil film may fail and metal-to-metal contact may occur. If the oil's viscosity is too high with a low potential shear rate, the internal resistance to flow will increase the temperature dramatically, causing an overheated condition, which can also cause a breakdown of the oil film and may cause oxidation of the oil. Therefore, it is critical that oils be selected by always taking the operating temperature of the equipment into account.

The most common term describing viscosity is kinematic viscosity, which is measured in centistokes (cSt) at 40 degrees C and 100degrees C, respectively. These specifications are always listed on oil company data sheets.

Pour Point

The pour point of an oil is defined as the lowest temperature at which a lubricant will flow. It is frequently and erroneously used as the oil viscosity selection criteria.

For example, let's say an oil has a pour point of minus 30 degrees C. Most people assume that this means that the oil will flow to the bearings of the equipment even when the ambient temperature is at minus 30 degrees C. This is a fallacy . At best, this oil with a pour point of minus 30 degrees C and operating in an ambient temperature of minus 30 degrees C will merely churn at the oil pump until the churning causes an increase in the oil's temperature. This in turn allows the oil's viscosity to thin sufficiently so that it slowly begins to flow through the oil passages to the lubricated components.

Frequently, this process takes 5 to 10 minutes or more, during which severe damage can occur at various components, because the oil is actually too thick to flow. Do not select lubricants based on pour point alone.

Viscosity Index

The viscosity index (VI) of an oil is the term used to express an oil's "resistance to viscosity change as the temperature changes." For example, an oil that thins out (reduced viscosity) significantly as its temperature increases is said to have a low VI. An oil whose viscosity does not change significantly as it is heated up is said to have a high VI.

This temperature/viscosity relationship is the most critical and important consideration when selecting oils that will be operated in temperatures that change dramatically. Viscosity index is of particular importance when selecting oils for northern US and western Canadian winters or high arctic operations.

Most industrial mineral lubricating oils that might be used in a manufacturing plant or production facility with controlled temperatures need only have VIs of 55B100. However, in an Alaskan mine facility or transportation operation, oils with VIs as high as 175 are available and may be necessary . Viscosity-index specifications are not always listed in oil company data sheets or specifications but should be.

Base Oil

The base oil should also be considered when selecting lubricants. Mineral-based (non-synthetic) oils have various bases depending upon their molecular and chemical structure. Base oils can be paraffinic, naphthenic or aromatic, and the selection process should take into account the type of base oil.

For example, naphthenic base oils have low natural VIs and may be selected for equipment where extreme temperatures do not affect operation. On the other hand, paraffinic base oils have natural VIs that are considerably higher than naphthenic types, making them desirable base stocks for lubricants used in outdoor applications. Fortunately, many of the natural mineral oils produced in North American oil fields are of the paraffinic type.